Welcome to Maintrac Services Custom Hydraulic Hose Builder
Please read the following carefully to help understand how to use the hose builder.
1. Select the the size hose you would like made - this is the internal size of the hose.
2. Select fitting for each end of the hose - for help working out which one is needed, measure the threads, internal for female or external for male, then use to the chart located in the images or click here.
3. Choose the length of the hose required - this is overall length from end of fittings.
4. If your hose needs to be a specific length that's not listed in the 500mm increments, then please provide this in mm (note: this needs to be less than the chosen hose length).
5. If you have chosen an angle fitting for both ends, please choose a rotation offset - e.g. 0 = both fittings in the same direction, 180 = each fitting is in the opposite direction.
If you have any issues or queries, please give us a call on (07) 533 1983.
1. Select the the size hose you would like made - this is the internal size of the hose.
2. Select fitting for each end of the hose - for help working out which one is needed, measure the threads, internal for female or external for male, then use to the chart located in the images or click here.
3. Choose the length of the hose required - this is overall length from end of fittings.
4. If your hose needs to be a specific length that's not listed in the 500mm increments, then please provide this in mm (note: this needs to be less than the chosen hose length).
5. If you have chosen an angle fitting for both ends, please choose a rotation offset - e.g. 0 = both fittings in the same direction, 180 = each fitting is in the opposite direction.
If you have any issues or queries, please give us a call on (07) 533 1983.